Kurzweil PC88 - Page 38

Chapter 3 Disassembly/Assembly
EMI Shields/Enclosure Support Wall
Before proceeding further, you must determine
whether the PC88 you are opening contains EMI Shields
or an Enclosure Support Wall and follow the appropriate
Disassembly / Assembly instructions.
To determine whether the PC88 you are opening
contains EMI Shields or an Enclosure Support Wall, place
the PC88 upside down on a soft surface. Refer to
illustration below and locate the 9 Phillips head screws
labelled A.
Figure 3.1
Enclosure Support Wall Screws
REMOVE
Rear Panel
Keyboard
Keyboard Screws
Do NOT Remove
If the unit does not have screws in these locations, the
unit contains EMI Shields. Please follow the
Disassembly/ Assembly Procedures for units containing
EMI Shields. These instructions begin on page 3-4.
If the unit you are opening has screws in these
locations, the unit contains an Enclosure Support Wall.
Please follow the Disassembly/Assembly Procedures for
units containing an Enclosure Support Wall. These
instructions begin on page 3-18.
PC88 Service Manual
3-2