Kushlan 450DD - Mixer Instructions; Lubrication and Maintenance Checks; Extension Cord and Cleaning

Mixer Instructions
A. LUBRICATION: ere are grease ttings on all models. Apply any type of EP grease until grease begins to come out of the
bearings. LUBRICATE ALL FITTINGS BEFORE EACH USE
B. GEARBOX MOTOR: Mixer shipped with lubricate/oil in gearbox. Change lubricate/oil every 200 hours. Use Synthetic
Mobile 1 LS 75W-90 oil.
C. EXTENSION CORD: Use only out door approved, 14 gauge or larger, grounded extension cords.
D. GENERAL: Check all screws for tight ness before each use.
E. CLEANING: Do not spray water on or into the motor. orough cleaning of the mixer aer each use is recom
mended and will add to the service life.
3