EasyManua.ls Logo

Kustom Defender V50 - The Defender Specifications

Kustom Defender V50
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
A m p S p e c i f i c a t i o n s
Model Defender 112 All-Tube Guitar Combo Amp with 12-inch speaker
Power Amp Tubes 2-EL34 power tubes using AUTOKRUISE™ biasing scheme
Preamp Tubes 3-12AX7 preamp tubes(2 preamp, 1 phase inverter)
Output Power 50 W RMS 16, 8, or 4 Ohms @ 5% THD
Speaker 1 X 12 inch KEI(Kustom-Eminence Integrated) EPIC-12, 16 Ohm
Input Impedance
Hum & Noise -63dBV Residual Noise, all level controls 0% (minimum), Bright Off, Presence @ 0
60 dB Nominal Gain, Volume @ 5
86 dB Maximum Gain, Volume @ 10
Gain = +10 dB Maximum gain of footswitchable volume boost
Gain = +3 dB Gain increase at 1 kHz when Bright is switched
Nominal Signal to Noise 60 dB Volume half and Master maximum, Boost on 10
Footswitchable Boost Master Volume Boost Adjustable from 0 to +10 dBV, nominal -6dBV
USA/Canada 120VAC/60Hz, 180W
Europe 230VAC/50Hz, 180W
UK 230VAC/50Hz, 180W
Australia 240VAC/50Hz, 180W
Japan 100VAC/50-60Hz, 180W
mm/kg 486 mm (Height) X 569 mm (Width) X 261 mm (Depth), 17.3 kg
inches/pounds 19.125" (Height) X 22.375" (Width) X 10.25" (Depth), 38 Lbs
1M Ohms
Tubes
Power Requirements
Footswitch
System Gain
Dimensions/Weight
Is compatible with single button Kustom Footswitch, part # KAC-FS100
Uses a standard mono shielded cable
The Defender Specifications

Related product manuals