Kustom KDA100 - Page 8

001ADKledoM
100W/8 ohm X 1
500mW/32 ohm X 2
-50 dBV
-45 dBV
Input Impedance 10K ohms
-16 dBV
-10 dBV
-10 dBV
-10 dBV
Line Out 0 dBV
Tone controls (EQ Centers) 60Hz, 800Hz, 10kHz
Crack 3.5KHz centered
180 W
14 W
1 x 10 inch woofer
2.5 inch (64mm) Tweeter
Dimensions English In.
Dimensions Metric cm
Weight 43 lbs/19.5 Kg
all controls turned down
all controls turned halfway
All Inputs
Post Input 1, 2 Aux In. Pre EQ, 3.5mm Line In
At full output
At idle
15 1/2" Deep, 17 1/4" Wide, 16.25" Tall (including feet)
3 band, 12 dBV, Center Flat
CCW (min.) flat, CW (max.) +12dBV
394mm Deep, 435mm Wide, 413m Tall (including feet)
Output Power (RMS 1% )
Frequency Response
Actual response is tailored for accurate acoustic
response for electronic drums
20-20KHz
Input Levels
Hum and Noise
AC Power Requirements
All measurements made at 1 kHz, EQ controls flat and volumes Max.
3.5mm LINE IN to achieve full output
AUX IN to achieve full output
Special design piezo
Speakers
KDA100 Specifications
Powered Drum Monitor
Internal Speakers
Output to Headphones (Mono Mix)
Special design 8 ohm rated 100W RMS
INPUT 1 to achieve full output
INPUT 2 to achieve full output