EasyManuals Logo

KVH Industries TracPhone V30 Installation Addendum

KVH Industries TracPhone V30
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
3
V30/H30 in 60 cm Dome Installation Addendum
Remove the Shipping Restraints
Follow these steps to detach the antenna from the
shipping pallet and remove the shipping restraints.
1. Remove the six #10-32 screws securing the radome to
the baseplate. Carefully lift the radome straight up until
clear of the antenna assembly and set it aside in a safe
place. If you keep the radome topside, secure it with a
lanyard to prevent it from falling overboard.
Figure 4: Removing the Radome
2. Remove the four 1/2"-13 bolts and washers securing
the antenna to the shipping pallet.
Figure 5: Shipping Restraints and Pallet Bolts
3. Transport the antenna to the mounting location.
4. Remove the foam shipping restraint. Save it for future
use.
5. Remove the tie-wrap shipping restraint from the
antenna frame.
IMPORTANT!
Once you have removed the restraints, handle the
antenna carefully, as its internal assembly will rotate
freely. Whenever you need to tilt the antenna, be sure to
guard against having the internal assembly swinging
around and potentially causing injury.

Other manuals for KVH Industries TracPhone V30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KVH Industries TracPhone V30 and is the answer not in the manual?

KVH Industries TracPhone V30 Specifications

General IconGeneral
BrandKVH Industries
ModelTracPhone V30
CategoryConference System
LanguageEnglish