Issue 4:
There is no data output through Serial Port #3.
Solution:
Serial Port #3 provides no output when GyroTrac is
configured as a component within a GyroTrac-compatible
TracVision system.
4.4 IRD Troubleshooting
The IRD that was provided with your satellite television service
may also be the cause of less-than-ideal operation. First check the
IRD’s configuration to ensure it is set up for the desired
programming. In the case of a faulty IRD, refer to your IRD user
manual for service and warranty information. If the IRD is both
configured properly and fully functional, contact your local KVH
dealer or service center for assistance.
4.5 Antenna Gyro and LNB Faults
Section 5, “Maintenance” on page 101 provides detailed instructions
for authorized service personnel who may be required to replace
the TracVision G6 antenna gyro or the LNB.
4.6 Computer Diagnostics
TracVision G6 has been designed to provide diagnostic readouts
viewed on a personal computer having an RS-232 serial
communication port. If you are unable to isolate a system
problem, set up for computer diagnostics as described below.
System problems will most likely be found somewhere through
the diagnostic readouts.
54-0161
98
TracVision G6 Technical Manual
To Next Page
Loading...
Need help?
General
