To Next PageTo Next PageWhat to do if the Kwazar ORION SUPER GARDEN PRO Paint Sprayer tank loses pressure and liquid appears in the pump cylinder?
If your Kwazar Paint Sprayer tank is losing pressure and spray liquid appears in the pump cylinder, it's likely due to a damaged head seal on the end of the cylinder pump. To resolve this, depressurize the tank using the safety valve, remove the pump, and inspect the head seal. If you find any damage, replace the seal.
Why is there no pressure in my Kwazar ORION SUPER GARDEN PRO tank when pumping?
If your Kwazar Paint Sprayer has no pressure in the tank when pumping, it could be due to a damaged seal on the pump piston rod. To fix this, depressurize the tank using the safety valve and remove the pump. Then, slide the piston rod out of the cylinder as far as possible. While holding the cylinder, turn the piston handle counterclockwise to undo the guides and remove the piston from the cylinder. Check the condition of the piston seal and replace it if damaged. Apply a small amount of silicone oil and reassemble the parts in reverse order.
What to do if the Kwazar ORION SUPER GARDEN PRO Paint Sprayer safety valve does not close or open?
If your Kwazar Paint Sprayer's safety valve isn't closing or opening properly, and the tank pressure is decreasing, the safety valve might be damaged. Try lubricating it with silicone oil by applying a few drops inside while the valve is open and operating it back and forth. If this doesn't solve the issue, consider replacing the valve.
How to fix low lance output pressure on a Kwazar Paint Sprayer?
If your Kwazar Paint Sprayer has low lance output pressure, it may be caused by a clogged filter in the lance handle or a clogged spraying nozzle on the lance tip. To resolve this, first remove the handle and check the filter for contaminants. Remove any you find. If the issue persists, unscrew the lance tip, remove the spraying nozzle, disassemble it into two pieces, clean it, and then reassemble.
General| Brand | Kwazar |
|---|---|
| Model | ORION SUPER GARDEN PRO Series |
| Category | Paint Sprayer |
| Language | English |
Emphasizes essential safety warnings for sprayer handling and storage.
Instructions for reading the manual and verifying the safety valve before use.
Guidelines on safe handling of chemicals and forbidden operations.
Guides on assembling the lance, hose, and suction tube connection.
Procedure to test the safety valve and release pressure from the tank.
Process for preparing spray liquid, pumping, and reaching operational pressure.
Instructions for thoroughly cleaning the sprayer with water after each use.
