1.Filling the water tank
Before first use, wash all the accessories and water tank with warm water.
1.)Remove the tank by pulling it upwards.
2.)Open the lid and fill the tank with fresh clean water, taking care not to exceed the MAX level. Put the
tank back in the appliance.
3.)More simply, the tank can also be filled without removing it, pouring the water directly from a jug.
Please note:
1.)Never operate the appliance without water in the tank or with-out the tank.
2.)It is normal for there to be water in the space under the tank. It should be dried regularly with a clean
sponge.
2.Preparation for the first use/the use under cold machine status
At first use, rinse the internal circuit as follows:
1.)Plug in the power supply and then press the button for 3 seconds, turn "Steam knob" to “Off”
position. The 3 buttons are flashing,which indicates the machine is heating up(preheating).
2.)When the lights stop flashing and remain on steadily, the appliance is ready for operating the rinse.
3.)Attach the funnel handle to the appliance.
4.)Place a large container under the boiler outlet and press button. When the water flows about
8-10oz, press to stop rinse.(You also can press or to flow hot water to rinse the appliance
inside)
5.)Empty the container and put it under the steam spout.
6.)Turn the “Steam Knob” to and press the button to release hot water to rinse steam
pipe.After 10 seconds,press the button again and turn “Steam Knob” to “Off” position to stop flowing
hot water.
3.Making Espresso Coffee/under the Hot Machine Status
For hotter espresso coffee, you should:
You are recommended to warm the cups before making coffee by rinsing them with a little hot water,or put
cups on the top of the appliance to warm them.
1.)Add coffee powder to 1cup filter or 2 cup filter.
2.)Keep the rim of filter clean.To avoid leaking or turning the funnel handle to LOCK position hardly.
To Next Page
