5-47
Operation on the Machine > Handling Destination
Confirmation Screen of Destinations
When selecting [On] for Destination Check before Send, the confirmation screen of destinations appears after pressing
the [Start] key.
Destination Check before Send (page 8-37)
1 Move the screen to the bottom and confirm all destinations.
Selecting [ ] (information icon) shows the detailed information of the destination.
To delete the destination, select the destination you want to delete > [Delete] > [Delete]
To add the destination, select [Close] and then return to the destination screen.
2 Select [Check].
Recall
Recall is a function allowing you to send the last entered destination once again. When you want to send the image to
the same destination, select [Recall], and you can call the destination you sent on the destination list.
1
Select [Recall].
The destination you sent is displayed on the destination list.
2
Press the [Start] key.
Sending starts.
Be sure to confirm all destination by displaying them on the touch panel. You cannot
select [Check] unless you have confirmed all destination.
When the last sending included FAX, folders and E-mail destinations, they are also
displayed. If necessary, add or delete the destination.
• When [On] is selected in "Dest. Check before Send", a destination confirmation screen is
displayed when you press the [Start] key.
Confirmation Screen of Destinations
(page 5-47)
• Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
To Next Page
Loading...
