6-70
Using Various Functions > Functions
Priority Override
Suspends the current job and gives a new job top priority.
The suspended job resumes after the other job is finished.
(Value: [Off] / [On])
Repeat Copy
Enables additional copies in the desired quantity as necessary after a copy job is completed.
For confidential documents, you can set up a password for the use of Repeat Copy. In such a case, the correct
password must be entered to perform Repeat Copy.
To register a password, enter a 4-digit password.
(Value: [Off] / [On])
Repeat Copy is not available when the Data Security Function is active.
When the maximum number of Repeat Copy jobs to retain in the document box is set to 0 (zero), this function cannot be
used.
Repeat Copy Job Retention (page 8-47)
You can select Repeat Copy as the default setting.
Repeat Copy (page 8-34)
Giving a file name to a copy job will facilitate identification of the data when copying.
File Name Entry (page 6-69)
Repeat Copy
The Repeat Copy jobs are stored in the Job Box. Refer to Outputting Repeat Copy Jobs to print out the Repeat Copy
jobs.
Outputting Repeat Copy Jobs (page 5-64)
Advanced
Setup
Functions Functions
• This function is not available if current job was an override.
• Priority override may not be available depending on the status of the current print job and memory usage. In this
case, try the interrupt copy.
Interrupt Copy
(page 5-20)
Advanced
Setup
• A Repeat Copy job is cleared when the power switch is turned off.
• If you forget the password, Repeat Copy cannot be performed for that document. Make a note of the
password beforehand if necessary.
Custom
Box
USB
Drive
To Next Page
Loading...
