8-19
Setup and Registration (System Menu) > System Menu
Paper Source for
Cover
Select the paper source in which the cover paper used for the Cover function is placed.
Value: Cassette 1 (to 4), MP Tray
[Cassette 2] to [Cassette 4] are displayed when the following optional paper feeder is
installed.
[Cassette 2]: When a paper feeder (500-sheet) is installed.
[Cassette 3]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (2,000-
sheet) is installed.
[Cassette 4]: When a paper feeder (500-sheet x 2) is installed.
Separator Paper
Source
Select the default paper source for separator sheets.
Value: Cassette 1 (to 4), MP Tray
[Cassette 2] to [Cassette 4] are displayed when the following optional paper feeder is
installed.
[Cassette 2]: When a paper feeder (500-sheet) is installed.
[Cassette 3]: When a paper feeder (500-sheet x 2) or large capacity paper feeder (2,000-
sheet) is installed.
[Cassette 4]: When a paper feeder (500-sheet x 2) is installed.
Special Paper Action When printing on Prepunched, Preprint, and Letterhead, punch-holes might not be aligned
or the print direction might be upside-down depending on how originals are set and the
combination of copying functions. In such a case, select [Adjust Print Direction] to adjust
the print direction. When paper orientation is not important, select [Speed Priority].
If [Adjust Print Direction] is selected, load paper according to the steps below.
Example: copying on Letterhead
Value: Adjust Print Direction, Speed Priority
Item Description
Multipurpose TrayCassetteFinishedPaperOriginal
Multipurpose TrayCassetteFinishedPaperOriginal
To Next Page
Loading...
