Kyocera 408ci - Page 406

8-23
Setup and Registration (System Menu) > System Menu
Toner Settings
[System Menu/Counter] key > [Device Settings] > [Toner Settings]
Auto Error Clear If an error occurs during processing, processing stops to wait for the next step to be
taken by the user. In the Auto Error Clear mode, automatically clear the error after a
set amount of time elapses.
Value: Off, On
NOTE
If you select [On] for Auto Error Clear, set the amount of time to wait before
automatically clearing errors. The setting range is 5 to 495 seconds (in 5 second
increments).
Continue or Cancel Error
Job
Set which users can cancel or continue operations for jobs which were paused due to
an error.
Value: All Users, Job Owner Only
NOTE
Administrator can cancel all jobs regardless of this setting.
Item Description
Color Toner Empty Action Select whether printing is prohibited or the Print in Black and White setting is used for
printing once the color toner runs out.
Value: Stop printing, Print in Black & White
NOTE
This setting is not valid when the optional Fiery Controller is installed.
Low Toner Alert Set the amount of remaining toner to notify the administrator when to order a toner
when the toner is running low.
This notification is used for event report, Status Monitor, SNMP Trap.
Value: Off, On
NOTE
If [On] is selected, set the amount of remaining toner to alert. The setting range is 5 to
100% (in 1% increments).
Item Description