Kyocera 408ci - Page 438

8-55
Setup and Registration (System Menu) > System Menu
Wired Network Settings
[System Menu/Counter] key > [Network Settings] > "Network Settings" [Wired Network Settings]
Configure wired network settings.
TCP/IP Setting
Item Description
TCP/IP Select whether to use TCP/IP Protocol.
Value: Off, On
IPv4 Settings Set up TCP/IP (IPv4) to connect to the network. This setting is available when [TCP/
IP] is set to [On].
DHCP Select whether to use the DHCP (IPv4) server.
Value: Off, On
Auto-IP Select whether to use Auto-IP.
Value: Off, On
IP Address Set the IP address.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], the value cannot be entered.
Subnet Mask Set the IP subnet mask.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], the value cannot be entered.
Default Gateway Set the IP gateway address.
Value: ###.###.###.###
NOTE
When DHCP is set to [On], the value cannot be entered.
DNS Server Address Set the IP address of DNS (Domain Name System) server.
Value: Use DNS Server from DHCP, Use following DNS Server
NOTE
When [Use following DNS Server] is selected, you can enter static DNS server
information in the Primary and Secondary fields provided.
IMPORTANT
• When setting the Auto-IP, enter "0.0.0.0" in [IP Address].
• After changing the setting, restart the network or turn the machine OFF and then ON.