Kyocera 408ci - Obtain NW User Property

9-25
User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
Obtain NW User Property
Set the required information to obtain the network user property from the LDAP server. The user name and E-mail
address obtained with this setting is shown in the user information, the status confirmation screen, and the header of
E-mail.
1
Display the screen.
1 [System Menu/Counter] key > [Job Accounting/Authentication]
2 Select "User Login Setting" [Obtain NW User Property].
2
Configure the settings.
Select [On] for "Obtain NW User Property" and add information on each item
NOTE
To obtain the network user property from the LDAP server, [Network Authentication] must be selected for the
authentication method in "Enabling User Login Administration". Select [On] for "LDAP" in "Protocol Settings".
Enabling User Login Administration (page 9-3)
Protocol Settings (page 8-57)
NOTE
If the login user name entry screen appears during operations, enter a login user name
and password, and select [Login]. For this, you need to login as an administrator or as a
user with privileges to carry out this setting.
The factory default login user name and login password are set as shown below.
Item Descriptions
LDAP Server Information
Server Name
*1
Enter the LDAP server name or the IP address (up to
64 characters). If a server name is not entered, user
information will be acquired from the server set for Network
Authentication.
Port Port number for LDAP server. The default port number is
389.
Acquisition of User Information
Name 1
*2
Enter the LDAP Attribute to obtain the user name to be
displayed from the LDAP server (up to 32 characters).
Name 2
*3
Enter the LDAP Attribute to obtain the user name to be
displayed from the LDAP server (up to 32 characters).
Email Address
*4
Enter the LDAP Attribute to obtain the E-mail address from
the LDAP server (up to 256 characters).
Model Name Login User Name Login Password
358ci 3500 3500
408ci 4000 4000
508ci 5000 5000