Kyocera 408ci - Page 554

10-35
Troubleshooting > Troubleshooting
6
Select [Device Information/Remote Operation] > [Remote
Operation].
7
Click [Start] button.
When the Remote Operation is started up, the operation panel screen will be displayed on the
system administrator's or user's PC screen.
Executing Remote Operation from VNC Software
1
Display the screen.
[System Menu/Counter] key > [Network Settings] > "Network Settings" [Protocol Settings]
2
Set "Enhanced VNC (RFB)" to [On].
Protocol Settings (page 8-57)
3
Startup the remote operation.
1 Start up the VNC software.
2 Enter the following format separated by a colon to start up the remote operation.
"IP address: port number"
NOTE
• If the user is logged in to the device, the permission confirmation screen will be displayed
on the operation panel. Select [Yes].
• If pop-up blocking of the browser occurs during connection of the Remote Operation,
select Always allow pop-ups from https:// [host name], and click Done. Perform Remote
Operation after waiting 1 minute or more.
NOTE
• When setting "VNC (RFB) over SSL" to [On], the communication is encrypted.
• You can configure the protocol settings using Command Center RX.
Command Center RX User Guide
NOTE
When setting "VNC (RFB)" to [On] in step 2, the default port number is 9062. When
setting "VNC (RFB) over SSL " to [On], the default port number is 9063.
Protocol Settings (page 8-57)