Kyocera DP-480 - Page 346

2NC/2NF/2NG/2NN/3P7/3P8/3P9
1-5-68
37. Remove the screw.
38. Remove the exit rear cover forward with
releasing two projections by lifting it up.
Figure 1-5-118
39. Remove the connector from the high
voltage PWB.
40. Remove three screws and unhook the
hook and then remove the high voltage
PWB.
41. Check or replace the high voltage PWB
and refit all the removed parts.
Figure 1-5-119
Screw
Exit rear cover
Projection
Projection
Connector
Screw
Screw
Screw
High voltage PWB
High voltage PWB
Hook