Troubleshooting > Troubleshooting
344
"Cannot execute this job. Restricted by Authorization settings." is
displayed
Restricted by the authorization settings.
The job is canceled. Select [OK].
Restricted by the job accounting.
The job is canceled. Select [OK].
NOTE
If Auto Error Clear is set to [On], the process will resume automatically after a set period of time. For details, refer
to the following:
➡ Auto Err. Clear (page 230)
"Cannot read data in this ID Card." is displayed
In registration process, the ID card information was not read correctly.
Hold the IC card over the IC card reader again. If the same message is displayed again, the IC card may not be
compatible with this product. Replace it with another IC card.
"Cannot recognize." is displayed
• Check if the USB connector of your IC card reader is correctly connected to the main unit.
• If [USB Host] in [I/F Block Set.] is set to [Block], change it to [Unblock].
"Cannot use the?cassette below due to?a failure." is displayed
To continue as is, select [OK]. If repair is completed, select [Next].
"Shake the toner container." is displayed
Open the top cover and take out the toner container. Shake the toner container well and set it again.
To Next Page
Loading...
