2JN-2
1-3-32
U144
Setting toner loading operation
Description
Sets toner loading operation after completion of copying. Toner is forcibly evacuated in case the average print-
ing ratio for the number of printed pages assigned by [PAGE] is lower than the ratio defined by [RATIO].
Purpose
To set whether or not toner is loaded on the drum after low density copying. Normally no change is necessary
from the initial setting.
Setting
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
3. Change the setting using the cursor left/right keys.
4. Press the start key. The value is set.
5. Turn the main power switch off and on.
U157
Checking the developing drive time
Description
Displays the developing drive time for checking.
Purpose
To check the developing drive time after replacing the developing unit.
Method
1. Press the start key. The developing drive time is displayed in minutes.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Maintenance
item No.
Description
Display Description Setting range Initial setting
T7 MODE Toner loading operation 1 (ON) / 0 (OFF) 1
STEP1 PAGE Number of pages set (step1) 0 to 50 3
STEP2 PAGE Number of pages set (step2) 0 to 50 8
STEP3 PAGE Number of pages set (step3) 0 to 50 20
STEP1 RATE Printing ratio (step1) 0 to 100 1
STEP2 RATE Printing ratio (step2) 0 to 100 2
STEP3 RATE Printing ratio (step3) 0 to 100 3
Display Description
TIME(min) Developing drive time
To Next Page
Loading...
