Kyocera FS-1700 - Page 16

16
3. Press the ENTER key. A question mark (?) appears.
Bulk feeder size
? A4
4. Each time you press the + key, the message display shows another of the
paper sizes indicated in the table above. Continue pressing + until the
desired size appears, then press ENTER.
5. To finish selection and return message display to Ready, press the EXIT
key.
Selection Using PRESCRIBEs CASS Command
Feed selection can be done using the CASS command of the PRESCRIBE
command language. To switch paper feed to the option bulk paper feeder, place
the CASS command in a file or program as follows.
!R! CASS 0; EXIT;
When the printer receives the CASS command, it automatically does a form feed
operation. Therefore, the CASS command should be sent either at the beginning
of the file, or at the beginning of an intermediate page.
The PRESCRIBE FRPO R4 command changes the printers default (power-on)
paper cassette setting. To change the power-on paper source to the optional bulk
paper feeder, use the following command sequence.
!R! FRPO R4, 0; EXIT;
Note When the optional bulk paper feeder is installed, the printer
ignores the PRESCRIBE FRPO T0 command (Auto/manual
feed setting).
All manuals and user guides at all-guides.com
all-guides.com