6-4
FS-1800/1800N | FS-3800/3800N
6-1 Troubleshooting
6-1-1 General error handling
(1) Maintenance messages
Message Corrective action
Add paper
(paper source)
Check waste
toner bottle
Clean printer
Press GO
Duplexer
rear cover open
Face-down tray
paper full
: Alarm buzzer sounds when an error occurs. Press the CANCEL key to stop the alarm buzzer.
The paper has run out. Supply paper according to the paper source
displayed (paper cassette, MP tray, or option paper feeder).
Messages indicating the printer status (Ready , Please wait
Processing *, Waiting, and FormFeed Time Out *) are
displayed alternately.
* These messages will not appear if the number of copies is set to
2 or more.
The waste toner bottle is not installed. Replace the old waste toner
bottle with the new one which is included in the TK-60/TK-60E
toner kit. The message will also be shown if the waste toner bottle
has become full. The waste toner bottle should be replaced when
the message display eventually shows Toner low TK-60. See
section Toner container replacement on page 3-5.
Clean the inside of the printer, according to section 3-1-3 Cleaning
the printer on page 3-8. This message will be displayed when
replacing the toner container after the message Replace toner
TK-60 has been displayed. After cleaning the inside of the printer,
press the GO key and the printer will be ready for printing. If
Auto Continue is set to On, printing will be automatically resumed
after a preset period of time.
Open the option duplexer rear cover, then close tightly.
The face-down output tray has become full (approximately 250
pages). Remove all printed pages from the face-down output tray.
When the printer senses that the face-down output tray is empty
again, it will continue printing into the face-down output tray.
To Next Page
Loading...
