Kyocera FS-1800 - E3 Laser Scanner Unit (Pin Photo Diode Sensor) Error

6-19
FS-1800/1800N | FS-3800/3800N
(15) E3 Laser scanner unit (Pin photo diode sensor) error
Yes
No
Yes
No
No
Call service
personE3:0123456
Print status page.
Turn power switch off.
Turn power switch on.
Print status page.
Remove and check
harness between
engine board (KP-864)
and laser scanner unit.
+24 V DC
at #1 pin of YC601
on APC board
(KP-742) ?
Yes
Yes
No
Replace harness between
engine board (KP-864)
and laser scanner unit.
OK?
Replace engine board
(KP-864). See page 5-22.
Replace engine board
(KP-864). See page 5-22.
Replace laser scanner
unit. See page 5-37.
Does
pin #4 (LASER*) of
YC601 on APC board
(KP-742) goes high and
then low?
Pin #8 (_PDIN*)
of YC601 on APC board
(KP-742) output pulse
signal*
1
?
*
1
: Pin photo diode sensor
[board KP-746] detecting
horizontal synchronization signal
[FS-1800/1800N]
Frequency: 2.3 kHz,
Low level width: 1.4 µs
[FS-3800/3800N]
Frequency: 3.5 kHz,
Low level width: 1.0 µs
Harness (S02404) scanner unit
and engine board (KP-864)
Engine board (KP-864) and scanner
unit (replace at the same time)
NOTE:
If the problem is not solved by
this flow chart replace the
following items:
Meaning Suggested causes Corrective action
Laser beam detection
failed. The pin photo
diode sensor [board]
(KP-746) does not
deliver a horizontal
synchronous
signal (PD*).
• No laser beam due to the laser diode defect
(PD*).
• Soiled or defective pin photo diode sensor.
• Defective gate array U204 of engine board.
• Improper connector insertion.
• Defective harness between engine board and
laser scanner unit.
Follow the flow chart
below.