Kyocera FS-1800 - Repetitive Defects Gauge

6-47
FS-1800/1800N | FS-3800/3800N
Repetitive defects gauge
Use the following measurements for checking repetitive occurrences on the printed page. This will
help locating the roller, etc., which has the cause for these defects. See the above section for details.
Figure 6-1-2 Repetitive defects gauge
First occurrence of defect
[39 mm] Developing roller (Developer)
[50 mm] Upper and Lower registration roller
[72 mm] Heat roller (Fuser unit) [FS-1800/1800N]
[94 mm] Heat roller (Fuser unit) [FS-1800/1800N]
Drum (Drum unit)
[79 mm] Press roller (Fuser unit)
[62 mm] Transfer roller