3-21
FS-1800/1800N | FS-3800/3800N
(3) Downloading operator panel message data
To download data from the parallel interface, proceed as follows.
CAUTION Downloading operator panel message data takes several minutes. Do not turn
power off during downloading.
Perform in sequence Display shows
1 Turn printer power on.
2 Make sure the printer is Ready.
3 At the DOS prompt, send the following command
to the printer:
>ECHO !R!BOOT’SPR’;EXIT;>PRN
Note: Do not add an EXIT; command in the above.
4 The message display should indicate Supervisor
mode.
5 Copy the message data to the printer by typing:
>COPY\B panel message file. name PRN
6 Check the display reverts to Ready.
7 Turn power on again. Check the printer gets Ready.
If the message display indicates Call service personDn (n=0, 1, ...), refer to section
Downloading error on next page.
Supervisor mode
parallel waiting
Ready
Ready
Downloading
To Next Page
Loading...
