FS-1900
5-24
(3) Removing the main board
CAUTION Before removing the main board, the memory card must be removed first.
However, do not remove the memory card while power is on. If the memory card
is removed (or inserted) while the printer is on, damage could result in the printer’s
electronics as well as the memory card.
1. Turn the power switch off.
2. Remove the memory card that may be inserted in the memory card slot 1 at the left side of the
printer.
3. Remove two screws 2.
4. Pull the main board 3 all the way out of the printer.
Figure 5-2-21 Removing the main board
3
2
1
2
To Next Page
Loading...
