2F8/2F9/2GA-2
1-6-5
(3) Downloading the firmware from the USB memory
The procedure below provides how to download firmware from a memory card.
Note that you can’t download both the system and engine firmware at a time.
1. Turn printer power off.
2. Connect the USB memory to the PC.
3. Copy the firmware file to the root directory of
the USB memory.
4. Remove the USB memory from the PC and
then insert the USB memory into the
printer's USB memory slot.
Figure 1-6-9
5. Turn printer power on.
6. When message display (1) is displayed to
detect firmware in the USB memory.
7. Message display (2) is displayed during
downloading.
8. When message display (3) is displayed to
indicate downloading is finished.
9. Turn printer power off.
10. Remove the USB memory from USB mem-
ory slot.
11. Turn printer power on.
12. Confirm that message display (4) is dis-
played after warm-up.
13. Print the status page. Print the status page
to check that the firmware version has been
updated.
Figure 1-6-10
USB memory slot
USB memory
(2)
(1)
(4)
Ready
Supervisor mode
USB data reading
Supervisor mode
(3)
2GA_3000.001.021
05/10/26 [E1F9]
Message display
Supplement (Normally: 00)
Classification (Normally: 0)
Product code
2F8: 30/31 ppm printer (EUR/USA model)
2F9: 35/37 ppm printer (EUR/USA model)
2GA: 45/47 ppm printer (EUR/USA model)
Release date: Year/Month/Day
Checksum
Update history
Build number
Firmware category
10: Engine controller
30: Main controller
Power switch: On
Power switch: On
Power switch: Off
USB
memory
slot
USB
memory
NOTE:
Main controller firmware "2F9" should
be used since 35/37 ppm printer and
45/47 ppm printer are identical.
To Next Page
Loading...
