Kyocera FS-2000D - Page 84

2F8/2F9/2GA-3
1-5-12
1-5-6 Transfer/separation section
(1) Detaching and refitting the transfer roller and separation charger brush unit
Procedure
1. Remove the developer unit (See page P.1-5-
9).
2. Remove the drum unit (See page P.1-5-10).
3. Slide the paper chute guide and unhook the
hooks.
4. Remove the paper chute guide.
Figure 1-5-15
5. Remove the shaft (transfer roller) from the
both bushes.
Figure 1-5-16
Paper chute guide
Hook
Hook
Hook
Hook
Transfer roller
Shaft
Transfer roller
Bush
Transfer roller
Bush
Transfer roller
Shaft