Kyocera FS-2000D - Page 92

2F8/2F9/2GA-1
1-5-20
6. Remove the heat roller (See page P.1-5-17).
7. Remove the one screw and then remove the
fuser thermistor M/S.
Figure 1-5-25
8. Remove the one screw (nut) and then
remove the fuser thermistor M (35/37 and
45/47 ppm printer [EUR/USA model] only).
Figure 1-5-26
Fuser thermistor S
Fuser thermistor M
Screw
Screw
30/31 ppm printer
(EUR/USA model)
35/37 and 45/47 ppm printer
(EUR/USA model)
Nut
Screw
Fuser
thermistor
M
35/37 and 45/47 ppm printe
r
(EUR/USA model)