Kyocera FS-2000D - Page 94

2F8/2F9/2GA
1-5-22
1-5-8 PWBs
(1) Detaching and refitting the engine PWB
Procedure
1. Remove the fuser unit (See page P.1-5-14).
2. Remove the top cover (See page P.1-5-2).
3. Remove the left cover (See page P.1-5-3).
4. Remove the PSU fan motor (See page P.1-
5-28).
5. Stand the printer front side up.
6. Remove the five screws and then remove
the bottom plate1.
7. Remove the four screws and then remove
the bottom plate 2.
Figure 1-5-28
8. Remove the two wires from the hooks and
notches.
9. Open the DU guide (duplex cover).
Figure 1-5-29
Screw
Bottom plate 1
Bottom plate 2
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Wire
Hook
Notch
DU guide (duplex cover)