Kyocera FS-2000D - Page 95

2F8/2F9/2GA-1
1-5-23
10. Detach the joint.
11. Remove the eight screws and then remove
the DU base.
12. Remove the cord cover (35/37 and 45/47
ppm printer [EUR/USA model] only).
13. Remove the connector (35/37 and 45/47
ppm printer [EUR/USA model] only).
14. Remove the six screws and then remove the
DU base.
Figure 1-5-30
15. Remove the four snaps.
16. Remove the one tab.
17. Remove the one screws and then remove
the grounding terminal.
Figure 1-5-31
DU base
Joint
Connector
Cord cover
Screw
Screw
Screw
Screw
Screw
Screw
Screw
Tab
Snap
Snap
Snap
Snap
Grounding
terminal