2F8/2F9/2GA-2
1-5-26
(2) Detaching and refitting the main PWB
Procedure
1. Remove the top cover (See page P.1-5-2).
2. Remove the right and left cover (See page
P.1-5-3).
3. Remove the six/seven connectors from the
main PWB.
4. Remove the two screws and then remove
the connect-R PWB.
5. Remove the wires from clamp.
Figure 1-5-34
6. Remove the six screws and then remove the
controller box (main PWB).
Figure 1-5-35
Connectors
(Six/Seven)
45/47 ppm printer
(EUR/USA model) only
Connect-R
PWB
Main PWB
Screw
Clamp
Screw
Screw
Screw
Screw
Screw
Screw
Controller box
To Next Page
Loading...
