Introduction
vi
To use equipment which does not comply with FCC rules is prohibited.
The printer may be optionally installed with the following units:
Conforming to the Class B limits
•
PK-Series KPDL 2 Upgrade Kit
•
IB-10 Serial Interface Board Kit
•
PF-16 Paper Feeder (250 sheets)
Interface connectors
Important note on the interface connectors
Be sure to turn off printer power before connecting or disconnecting an interface cable* to the printer.
For protection against static discharge which may be applied to the printer’s internal electronics through
the interface connector(s), keep any interface connector which is not in use capped using the protective
cap supplied.
* Use shielded interface cable.
Safety information
Laser safety
This printer is certified as a Class 1 laser product under the U.S. Department of Health and Human
Services (DHHS) Radiation Performance Standard according to Radiation Control for Health and Safety
Act of 1968. This means that the printer does not produce hazardous laser radiation. Since radiation
emitted inside the printer is completely confined within protective housings and external covers, the
laser beam cannot escape from the printer during any phase of user operation.
Laser notice
This printer is certified in the U.S. to conform to the requirements of DHHS 21 CFR Subchapter for Class
I (1) laser products, and elsewhere is certified as a Class I laser product conforming to the requirements
of IEC 825.
To Next Page
Loading...
