10
3. Password Protection.
Many of the configuration options in the MAP utility are password protected. The
default password is: sysadm The password is case sensitive. To change the
password, select Change Password in the System column.
4. NetWare Configuration.
➪ Select Setup NetWare in the Protocols column.
➪ Enter the Print Server Name, Preferred NDS Context, and Print Server
Password (if a password was defined) exactly as they were entered in
PCONSOLE. Note: Entries in MAP are not case sensitive (except the sysadm
password). Preferred File Server and Preferred NDS Tree should normally
remain blank unless Bindery mode is used or if the network includes multiple
NDS trees.
➪ If not using Bindery emulation, click the Disable Bindery box.
➪ Type the sysadm password in the appropriate box and click Accept Settings.
After a few seconds the screen should report that the update was successful.
Click the Back Arrow icon twice to return to the 2000E Configuration page.
➪ Optional: Click on Configure Status Page in the Printer column to define
powerup status page settings, (e.g. disabling the powerup status page).
➪ The changes made to the 2000E do not take effect until the unit is reset. Click on
Reset in the System column and click on the Reset Unit button. After a few
seconds the screen should report that the unit was reset.
5. Confirm Successful Configuration.
➪ After the Reset, the program advises waiting 2 minutes before reconnecting, but
the 2000E may be available sooner. From the Options menu, select Update
Server List and click the Down Arrow to display the list of Servers. Repeat if
necessary until the 2000E reappears and select it from the list.
➪ At the 2000E Configuration page, select Unit Status in the System column.
➪ Scroll down to display the NetWare status. The Queue Status should be
Attached.
➪ If the Queue Status is not Attached, please verify that the entries for Print Server
Name, Preferred NDS Context, and Print Server Password match those defined
in PCONSOLE or refer to the troubleshooting section in the User’s Manual.
To Next Page
Loading...
