Kyocera FS-600 - Windows NT Configuration

Windows NT Configuration
There are several options for setting up printing in a Windows NT environment.
◆ If a NetWare server is present, NetWare print services may be used by following the
NetWare configuration instructions in this guide.
◆ Peer to peer print services may be used by following the Windows Peer to Peer
Printing instructions in this guide, but are only available for Windows NT 4.0, not for
Windows NT 3.51. Peer to peer print services using the IPX protocol may be
preferable when TCP/IP setup is not desired.
◆ LPR print services may be used via TCP/IP by following the instructions in this
section.
Windows NT printing is very flexible. It is possible to configure the individual Windows NT
or Windows 95/98 workstations to print using a different protocol than the Windows NT
server. For example, a Windows NT server could be configured to print to a 2000E via
TCP/IP using the instructions in this section. The 2000E could then be designated as
shared on the NT server, allowing workstations to print via the NT server using a different
protocol (such as the default NetBEUI).
The optimum Windows NT printing configuration depends upon the particular environment
and user and administrator experience and preferences. Generally, the LPR printing
over TCP/IP covered in the following instructions is the best choice for environments
where TCP/IP is already in use.
TCP/IP Required Components
The Windows NT system performing the 2000E configuration must have the TCP/IP
protocol installed. The following steps describe how to check for and, if necessary, add
the required TCP/IP components.
Windows NT 3.51
1. In the Program Manager group Main, double click on Control Panel.
2. Double click on Network and check the list of Installed Network Software for the
following three components:
Microsoft TCP/IP Printing, Simple TCP/IP Services, & TCP/IP Protocol
3. If any of these components are missing, click on Add Software, select TCP/IP
Protocol and related components and click on Continue.
4. Select TCP/IP Network Printing Support and Simple TCP/IP Services and click
Continue.
5. After all necessary files are copied, click on OK to close the Network Settings dialog
and restart the system when prompted. The new protocol and/or services will not
be available until the system is restarted.
14