1-3-6
FS-6020
1. Remove the cassette from the printer.
2. Adjust the paper guides and the paper stopper
according to the paper size to be used.
3. Set the stack of paper that does not exceed the
paper upper limit marks on the paper guides and
the paper stopper by aligning the top of the stack
and placing the rear side first. (Approximate 250
sheets of 0.1 mm thick paper can be loaded.)
4. Turn the paper size dial so that the size of the
loaded paper is indicated in the paper size
indication window.
If “OTHER” is selected, paper size setting must
be performed on the operation panel of the
printer.
5. Install the cassette into the printer.
Loading paper.
Figure 1-3-9
Figure 1-3-10
Paper guides
Paper stopper
Paper size dial
Paper size
indication
window
To Next Page
Loading...
