FS-6020
1-4-4
Service items Description
Item Description
4 Software jumper switch information
(hexadecimal)
5 Total page
6 Toner installation information (displayed
only when the mode is set)
7 Parallel I/O information
8 Serial I/O error code (Not supported by this
machine)
9 Operation panel lock status (displayed only
when locked)
0 NVRAM error (displayed only when any
error has occurred)
! NVRAM downloading status
@ Printable area setting
# Left offset for each paper source
$ Page counter according to paper size
% Page counter according to paper feeder (2
or 3)
^ Page counter according to paper feeder (4
or 5)
[First byte/second byte (displayed in OEM mode only)]
First byte
Bit 0 = 1: (Fixed)
Bit 1 = 0: Overseas; 1: Domestic (Japan)
Bit 2, 3 (Not used)
Bit 4 = 0: Kyocera; 1: OEM
Bit 5 = 0: For Europe; 1: For US
Bit 6 = 0: Non MICR mode; 1: MICR mode
Bit 7 = 0: Kyocera; 1: Kyocera Mita
Second byte: Displayed in OEM mode only.
Total print page count
(Toner installation mode display) Standby mode
(After prescribe command TNRE “INST” is entered, until the
power is turned off)
-
00: Normal
Bit 0: Framing error
Bit 1: Overrun error
Bit 2: Parity error
01: Partial lock
02: Full lock
01: ID error
02: Version error
03: Checksum error
04: NVRAM crash error
00: Normal (not downloaded)
Bit 0: Font data
Bit 1: Host data
Bit 2: Macro data
Bit 3: Program data
Bit 4: Operation panel message data (file name displayed)
Bit 5: OEM data (file name displayed)
Bit 6: Reserved
Bit 7: Error occurred
/Top offset/Left offset/Page length/Page width
/MP tray/Cassette 1/Cassette 2/Cassette 3/Cassette 4
/Cassette 4/Duplexer
/Legal/Small/
“Small” means sizes smaller than legal and that can be fed.
/Feeder 2 (total)/Feeder 2 (small)/Feeder 2 (large)
/Feeder 3 (total)/Feeder 3 (small)/Feeder 3 (large)
* “Total” is calculated by adding the number for “small” to 2 ×
number for “large” (double count).
* “Small” means sizes of which the length in the sub-scan
direction is less than 335 mm (length of legal size), and
“large” means sizes of which the length is 335 mm or more.
/Feeder 4 (total)/Feeder 4 (small)/Feeder 4 (large)/Feeder 5
(total)/Feeder 5 (small)/Feeder 5 (large)
* “Total” is calculated by adding the number for “small” to 2 ×
number for “large” (double count).
* “Small” means sizes of which the length in the sub-scan
direction is less than 335 mm (length of legal size), and
“large” means sizes of which the length is 335 mm or more.
To Next Page
Loading...
