FS-6020
1-6-17
1-6-6 Transfer/separation section
(1) Detaching and refitting the transfer roller and separation charger unit
Perform the following procedure when the transfer roller or separation charger unit is to be checked or replaced.
Procedure
1. Remove the process unit.
2. Open the upper paper chute.
3. While sliding the lower paper guide and then
remove the hooks.
4. Remove the transfer roller.
5. Remove the transfer roller gear Z18 from the
transfer roller.
6. Remove the four hooks and then remove the
separation charger unit.
7. Check or replace the transfer roller/separation
charger unit.
8. Refit all the removed parts.
Figure 1-6-20
Separation charger unit
Transfer roller
Transfer roller
gear Z18
Claw
Upper paper
chute
Hook
Lower paper guide
To Next Page
Loading...
