FS-6020
1-6-26
(2) Detaching and refitting the engine/high voltage PWB
Perform the following procedure when the engine/high voltage PWB is to be checked or replaced.
Procedure
1. Remove the top cover (see page 1-6-2).
2. Remove the left cover (see page 1-6-3).
3. Remove the right cover (see page 1-6-4).
4. Remove all (nine) connectors from the
engine/high voltage PWB.
5. Remove the power source PWB (see page 1-
6-28).
Figure 1-6-32
6. Remove the two connectors from the main
PWB and one connector from the main motor.
Figure 1-6-33
Engine/high voltage
PWB
Connectors
Connectors
Connector
To Next Page
Loading...
