Appendix A Host Computer Interface
A-6
With Windows 95/98/Me, make settings as follows:
Click on the Start button in the Windows 95/98/Me
task bar and align the cursor with Settings, then
click on Control Panel from among the items dis-
played.
The Control Panel window opens. Double click on
System.
System Properties window opens. Click on the
Device Manager tab, then double click on Ports
(COM & LPT).
Double click on Communications Port.
The Communications Port Properties dialog is dis-
played for the selected COM port. Click on the Port
Settings tab and set the port properties.
After setting the properties, click the OK button.
In DOS, enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
1
2
3
4
5
6
To Next Page
Loading...
