Kyocera FS-6020 - Printing Information Pages; Printing the Menu Map; Printing the Status Page

Chapter 1 Using the Operator Panel
1-10
This section explains the procedures to print out the print-
er’s internal information.
You can print out such information as the set menu, printer’s
status, font list as well as a dump list of received hexadecimal
data.
The printer prints a full list of menu selection system. Note
that menus indicated on the list may vary depending on
which option units are installed on the printer.
Press the MENU key.
Press the or key repeatedly until Print Menu
Map appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. The printer prints a
menu map.
If you want to check the printer’s current status, including
memory available and option settings, you can find the infor-
mation you need on the status page.
Press the MENU key.
Press the or key repeatedly until Print
Status Page appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. The printer prints a
status page.
For a full description of the status, see the following
Printing the Service Status Page on page 1-11.
The following is a sample status page. The numbers below re-
fer to the contents explained on the next page.
Printing Information Pages
Printing the Menu Map
Print
Menu Map
Print
Menu Map ?
1
2
3
4
MENU MAP
Printing the Status Page
Print
Status Page
Print
Status Page ?
NOTE
1
2
3
4
STATUS PAGE
0 100
HardwareInformation
PageInformation
NetworkStatus
Memory
InstalledOptions
Emulation
ErrorLog
TonerGauge
Interfaces
KIR Test pattern
ON
1
3
5
7
8
2
4
6
10
11
9