Chapter 1 Using the Operator Panel
1-19
Press the key.
Press the or key repeatedly until >MP Tray
Type appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to display the desired MP tray
paper type. The display changes as shown below.
Plain
Transparency
Preprinted
Labels
Bond
Recycled
Vellum
Rough
Letterhead
Color
Prepunched
Envelope
Cardstock
Thick
Custom1(to 8)*
* You can define and register a desired paper type to
the printer in advance. See
Customizing the Paper
Type
below for details.
When the desired MP tray paper type is displayed,
press the ENTER key.
Press the MENU key and the message display re-
turns to Ready.
Customizing the Paper Type
The following describes the procedure to be used to set a
user-defined paper type for the printer. Eight custom user
settings may be registered. Once registered, any of these
may be called up when setting the paper type for a paper
source.
The paper weight and duplex path can be set (see
Setting the
Paper Weight
and
Setting the Duplex Path on page 1-20
). To
reset the customized settings, see
Resetting the Type Adjust
on page 1-21
.
Press the MENU key.
Press the or key repeatedly until Paper
Handling > appears.
Press the key.
Press the or key repeatedly until >Type
Adjust > appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to display the desired paper
type. The display changes as shown below.
Custom1(to 8)
Plain
Transparency
Preprinted
Labels
Bond
Recycled
Vellum
Rough
Letterhead
Color
Prepunched
Envelope
Cardstock
Thick
When the paper type to be customized is displayed,
press the ENTER key.
Press the key and proceed to
Setting the Paper
Weight
and
Setting the Duplex Path on page 1-20
.
Paper Handling >
>MP Tray Type
Plain
>MP Tray Type
? Plain
3
4
5
6
7
8
Paper Handling >
>Type Adjust >
Custom 1
>Type Adjust
? Custom 1
1
2
3
4
5
6
7
8
To Next Page
Loading...
