Chapter 1 Using the Operator Panel
1-28
Press the or key repeatedly until the desired
font number appears. For font numbers of the inter-
nal fonts, see
List of Fonts on page 5-1
.
When the desired font is displayed, press the ENTER
key.
Press the MENU key. The message display returns to
Ready.
Changing the Type for Courier/Letter Gothic
Courier or Letter Gothic font type can be selected as Regular
or Dark. For example, to change the type of Courier, proceed
as follows:
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key.
Check that Internal is displayed and press the
key.
Press the or key repeatedly until >>Courier
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select Regular or Dark using the or key.
Press the ENTER key.
Press the MENU key and the message display re-
turns to Ready.
Changing the Font Size
You can change the size of the default font. If the default font
is a fixed-pitch font such as Courier or Letter Gothic, the
character pitch can be changed instead of the font size.
Press the MENU key.
Press the or key repeatedly until Font > ap-
pears.
Press the key.
Check that Internal is displayed and press the
key.
Press the or key repeatedly until >>Size ap-
pears.
Press the ENTER key. A blinking cursor ( _ ) ap-
pears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking. The
font size can be set between 4 and 999.75 points, in
0.25-point increments. You can use the and
keys to move the cursor right and left.
When the desired size is displayed, press the ENTER
key.
Press the MENU key. The message display returns to
Ready.
>Font Select >
Internal
Font >
>Font Select >
Internal
>>Courier
Regular
>>Courier
? Regular
6
7
8
1
2
3
4
5
6
7
8
9
Font >
>Font Select >
Internal
>>Size
012.00 point(s)
>>Size
012
.00 point(s)
1
2
3
4
5
6
7
8
9
To Next Page
Loading...
