Kyocera FS-6020 - Deleting a Private;Stored Job; Printing a Code Job

Chapter 1 Using the Operator Panel
1-38
Press the or key to display the desired user
name (Arlen, in this example).
Press the ENTER key. The user name and the job
name (Agenda, in this example) entered in the
printer driver appear with a blinking question mark
(?).
Press the or key to display the desired job title.
Press the ENTER key. The ID input line appears.
Enter the four-digit access code entered in the print-
er driver and press the ENTER key. To enter the ID,
press the or key to move the cursor to the num-
ber to be changed and then enter the correct number
by pressing the or key.
In printing a stored job, the access code must be en-
tered in this step only when it has been set on the
printer driver.
You can set the number of copies to be printed. To in-
crease the copy count, press the key; to decrease
the copy count, press the key.
Press the ENTER key to finalize the copy count. The
printer prints the specified number of copies for the
job.
Deleting a Private/Stored Job
Follow steps 1 through 8 in the above section.
When the title of the job to be printed is displayed
(Agenda, in this example), press the ENTER key. En-
ter the four-digit access code entered in the printer
driver and press the ENTER key.
Press the key repeatedly until Delete appears
for the number of copies.
Press the ENTER key. The private/stored job is delet-
ed from the hard disk.
Printing a Code Job
KM-NET Job Manager
Install the KM-NET Job Manager software from the Kyocera
Mita Digital Library
CD-ROM supplied with the printer. To
do this, from the CD-ROM Main Menu, select Printer Utilities
> Install KM-NET Job Manager.
Browse through Windows Start > Programs >
KYOCERA MITA > KM-Net > Job Manager.
Click the Add printer icon (below). Select the Local
or Network port.
If you use the local parallel port to connect to the printer,
make sure that the printer driver is set to print to a local
port. To check this out, click the Details tab of the printer
Properties, and note the Print to the following port set-
ting.
Follow the wizard until the Select printer dialog box
is reached. When the printer is found in the Printer
List, click (highlight) it, then Finish.
>Private/Stored
?Harold
>Private/Stored
?Arlen
>Arlen
?Agenda
>Agenda
ID 0000
>Agenda
Copies 001
6
7
8
9
10
11
1
2
>Agenda
Copies 001
>Agenda
Delete
NOTE
3
4
1
2
Add printer
icon
3