Chapter 1 Using the Operator Panel
1-39
Double click Model Name on the list. The jobs cur-
rently stored in the printer are shown. To print the
job, right click Job name and then click Print on the
drop down list that appears.
It is possible to select more than one job at a time by
right clicking a job one by one while pressing the
Shift key on the computer keyboard.
The job remains intact even after printing. To permanently
delete the job in the hard disk, right click the job name on Job
Manager, then click Delete on the drop down list that ap-
pears.
Printing a List of Code Jobs
If you select permanent job storage on the printer driver, you
can have a list of code jobs printed using the operator panel.
A sample Code Job List is shown below.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >List of
Code JOB appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key again. The printer prints a
Code Job list as shown below.
You can store a job in the virtual mailbox. Specify the virtual
mailbox as destination through the printer driver. You can
print the stored jobs from the operator panel.
Jobs stored in the virtual mailbox are deleted when printing
is completed.
Printing Data Stored in Virtual Mailbox (VMB)
To retrieve and print the jobs posted in the virtual mailbox,
proceed as follows.
Press the MENU key.
Press the or key repeatedly until e-MPS > ap-
pears.
Press the key.
Press the or key repeatedly until >Print VMB
Data appears. The virtual mailbox number will also
appear.
If you have named the virtual mailbox with an alias
on the printer driver, the alias (Richard, in this
example) will follow the number:
e-MPS >
>List of
Code JOB
>List of
Code JOB ?
4
1
2
3
4
5
Using Virtual Mailbox (VMB)
e-MPS >
>Print VMB Data
Tray001:
>Print VMB Data
Tray001:Richard
6
PERMANENT CODE JOB LIST
1
2
3
4
To Next Page
Loading...
