Chapter 1 Using the Operator Panel
1-52
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until >CR Action
appears.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key repeatedly until desired car-
riage-return action appears.
CR only A carriage-return is performed.
(default)
CR and LF A carriage-return and linefeed are
performed.
Ignore CR The carriage-return code is ignored.
When the desired action is displayed, press the
ENTER key.
Press the MENU key. The message display returns to
Ready.
Turning this On increases the maximum number of charac-
ters that can be printed in a line for an A4 page (78 characters
at 10 pitch) and a Letter size page (80 characters at 10 pitch).
This setting is effective only in the PCL 6 emulation.
Press the MENU key.
Press the or key repeatedly until Page Set >
appears.
Press the key.
Press the or key repeatedly until >Wide A4 ap-
pears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
You can display the total number of pages printed by your
printer for confirmation whenever necessary. The total num-
ber of printed pages can also be checked on the status page.
Moreover, for proper maintenance scheduling, it will be nec-
essary to reset the toner counter using this menu each time a
new toner container is installed.
This procedure only displays the total number of printed
pages. The number cannot be changed.
Press the MENU key.
Press the or key repeatedly until Life
Counters > appears.
Press the key.
Press the or key until >Total Print appears,
followed by the current total printed pages
(0123456 in this example).
Press the MENU key. The message display returns to
Ready.
Page Set >
>CR Action
CR only
>CR Action
? CR only
Setting Wide A4
Page Set >
2
3
4
5
6
7
8
1
2
3
4
>Wide A4
Off
>Wide A4
? Off
Verifying the Total Printed Pages
Life Counters >
>Total Print
0123456
5
6
7
8
1
2
3
4
5
To Next Page
Loading...
