Chapter 1 Using the Operator Panel
1-53
If the toner container was replaced when Replace toner
TK-400 was not displayed, reset the toner counter as follows
so that an accurate toner gauge measurement is indicated on
the status page. Note that if this operation is performed
when the toner container is not replaced, the toner gauge
measurement will not be indicated correctly.
Also see the
Installation Guide
supplied with the toner kit
when replacing the toner container.
Press the MENU key.
Press the or key repeatedly until Life
Counters > appears.
Press the key.
Press the or key repeatedly until >New Toner
Installed appears.
Press the ENTER key. A question mark (?) appears.
Press the ENTER key. The toner counter is reset.
Press the MENU key. The message display returns to
Ready.
You can select the language of the messages on the message
display by following the procedure given below.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >MSG
Language appears. The default message language is
English.
To change the language, press the ENTER key. A
blinking question mark (?) appears.
Press the key. The display cycles through the
available selections in the following order (the key
cycles in the reverse order):
English
Francais
Deutsch
Italiano
Nederlands
Espanol
Portugues
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
When the printer receives no data for a certain time, it times
out and releases the current interface: it prints whatever
data it has in its buffer and feeds out the page. You can ad-
just the time-out time as follows:
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Form Feed
Time Out appears. The default setting is 0 seconds.
Resetting the Toner Counter
Life Counters >
>New Toner
Installed
>New Toner
Installed ?
Selecting the Message Language
Others >
1
2
3
4
5
6
7
1
2
3
>MSG Language
English
>MSG Language
? English
Setting the Automatic Form Feed Timeout
Others >
>Form Feed
Time Out 000sec.
4
5
6
7
8
1
2
3
4
To Next Page
Loading...
