Kyocera FS-6020 - Setting the (Buzzer) Alarm; Setting the Auto Continue

Chapter 1 Using the Operator Panel
1-56
When the desired mode is displayed, press the
ENTER key.
Press the MENU key. The message display returns to
Ready.
In addition to the message displayed when the paper supply
is exhausted, or when paper jamming occurs, an audio warn-
ing is made to sound. This is useful, for example, when the
printer is in a location some distance from the user.
The audio alarm is set to On (default).
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Buzzer ap-
pears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
If an error that still allows you to continue printing occurs
(Memory overflow Press GO, Print overrun Press
GO, KPDL error Press GO, File not found Press GO,
RAM disk error Press GO, MemoryCard err Press
GO,and Hard disk err Press GO), the next received
data is automatically printed after a set period of time elaps-
es. For example, if the printer is shared over a network as a
network printer and one person causes one of the above er-
rors, after the set period of time elapses, the data sent from
the next person is printed. The default setting is On (Auto
Continue disabled).
For setting the auto continue recovery time, see the next sec-
tion.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Auto
Continue Mode > appears.
Press the ENTER key. A blinking question mark (?)
appears.
Select On or Off using the or key.
Press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Setting the (Buzzer) Alarm
Others >
>Buzzer
On
>Buzzer
? On
7
8
1
2
3
4
5
6
7
8
Setting the Auto Continue
NOTE
Others >
>Auto Continue >
Mode Off
>Auto Continue
Mode ? Off
1
2
3
4
5
6
7
8