Chapter 4 Troubleshooting
4-11
Paper is jammed in the rear cover. Remove the jammed paper
using the procedure given below.
Open the printer’s rear cover all the way.
Open the fuser cover as illustrated below. While
holding down the release lever (green-colored), re-
move the jammed paper as shown in the figure.
Close the rear cover.
Paper is jammed at the MP tray. Remove the jammed paper
using the procedure given below.
Remove the jammed paper.
Put all the paper out of the MP tray, align the edges
of the paper and reset the paper into the MP tray.
Jams in the Rear Cover
1
2
3
Jams at the MP Tray
1
2