Chapter 6 Option Units
6-5
PF-400 Paper Feeder can be installed below the printer.
For details of installing the optional paper feeder in the
printer, see the
PF-400 Operation Guide
.
DU-400 Duplexer can be installed to rear of the printer.
For details of installing the optional duplexer in the printer,
see the
DU-400 Operation Guide
.
Option network interface card is installed in the option inter-
face slot located at the rear of the printer. Take the following
steps to install option network interface cards. And also see
the documentation included with the option.
• The network interface card should be installed only by a
Kyocera Mita authorized dealer or Kyocera Mita certified tech-
nician. Kyocera Mita shall not be liable for damage due to im-
proper installation of the network interface card.
• The following instructions are intended for the technician only.
Turn off the printer and disconnect the power cord
and printer cable.
Remove the screws from the printer’s option inter-
face slot cover to remove the cover.
Insert the network interface card and secure it with
the screws removed in step 2.
Connect the network cable. Then, re-connect the
power cord to the outlet and the printer cable.
Turn on the printer and then set the network address
from the printer operator panel (for details about the
modes, see
Changing Option Network Interface
Parameters on page 1-44
).
PF-400 Paper Feeder
DU-400 Duplexer
Network Interface Card
NOTE
1
2
3
4
5
To Next Page
Loading...
