I/O Timeout
• USB
Specifies how many seconds the machine waits for print data, if the data is interrupted while it
is being sent from the computer via USB. If the machine does not receive any more data within
the time specified here, the machine only prints the data it has received. If printing is frequently
interrupted by data from other ports, increase the timeout period.
Default: 60 seconds
• 15 sec.
• 60 sec.
• 300 sec.
• Network
Specifies how many seconds the machine waits for print data, if the data is interrupted while it
is being sent from the computer via network. If the machine does not receive any more data
within the time specified here, the machine only prints the data it has received. If printing is
frequently interrupted by data from other ports, increase the timeout period.
Default: 60 seconds
• 15 sec.
• 60 sec.
• 300 sec.
• Locked Print
Specifies how many seconds the machine holds a new Locked Print file, when the machine
cannot store any more Locked Print files. Within this time, you can print or delete the new
Locked Print file. You can also print or delete an existing Locked Print file so that the new
Locked Print file can be stored in the machine.
Default: 60 seconds
• 0 to 300 seconds, in increments of 1 second
• User Authentication (Copy)
Specifies how many seconds a user stays authenticated after paper is output when copying
with the exposure glass. Note that authentication for other functions will expire immediately
after using that function.
This setting appears only when the user restriction function is enabled via COMMAND
CENTER.
Default: 30 seconds
• 5 to 60 seconds, in increments of 1 second
• Fixed USB Port
7. Configuring the Machine Using the Control Panel
270
To Next Page
Loading...
