Kyocera FS-C8500DN - Page 107

2KA
1-3-71
U246
Setting: [Punch Regist]
1. Change the setting value using the cursor up/down keys.
If skewed paper conveying occurs (sample 1), increase the preset value. If the copy paper is Z-folded
(sample 2), decrease the preset value.
Figure 1-3-7
2. Press the OK key. The value is set.
Setting: [Punch Pos.]
1. Change the setting value using the Left/Right Select keys.
If the distance of the position of a punch hole is smaller than the specified value A, increase the preset
value. If the distance is larger than the value A, decrease the preset value.
Figure 1-3-8
2. Press the OK key. The value is set.
Setting: [Width F HP/Width R HP]
1. Change the setting value using the Left/Right Select keys.
2. Press the OK key. The value is set.
Maintenance
item No.
Description
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of registration stop timing -20 to 20 0 1 ms
Sample 1 Sample 2
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of the paper stop timing -10 to 10 0 0.49 mm
A
Preset value A: 5.5
+
-
2 mm (inch)
9.5
+
-
2 mm (metric)
Description
Setting
range
Initial
setting
Change in
value per step
Adjustment of front side registration home position -10 to 10 0 0.31 mm
Adjustment of rear side registration home position -10 to 10 0 0.31 mm